SALES | D+H MECHATRONIC AG

KA 66-TW-K

  • Can be used for openings for smoke exhaust; D+H Euro SHEV in accordance with EN 12101‑2; and for daily ventilation

  • With BSY+ motor and synchronised electronics controlled via microprocessor

  • Direct control via 230 V AC

  • 2 drive chains for optimal power application to the sash

  • Special chain stabilisation

  • Relief of pressure on window gasket after closing process

  • Electronic force and position control

  • Programmable drive functions and different drive parameters

  • Running speed in CLOSED direction decreases to 5 mm/s (passive closing edge protection)

  • Time-controlled reversing when an obstacle is detected in the CLOSED direction (active closing edge protection)

Approvals / Certificates

These products are also available with the following approvals:
Find out about permission details from your D+H Partner.
You have further questions about this product? Contact us

Content of this page:

Designs and technical data

KA 66-TW-K
Duty cycle 30 % (ON: 3 min. / OFF: 7 min.)
Force of pressure 600 N
Tensile force 600 N
Nominal locking force ** 3000 N
Service life 20000 double strokes *
Stroke Configurable
OPEN running speed 12.2 mm/s
OPEN running speed - SHEV 16.1 mm/s
CLOSED running speed 11.8 mm/s
Type of protection IP 32
Show more information
Request & 
Compare
KA-TW-K-BSY+
Configure now

* For vertical use, please consult with D+H Sales!
** Depending on the mounting, *** in accordance with VdS 2580

Instruction for use
4.02 MB
CAD drawing
646.95 KB
download-icon
549.10 KB
download-icon
550.35 KB
download-icon
553.06 KB
download-icon
705.09 KB
download-icon
513.59 KB
download-icon
Tender documents
KA 66-TW-K

The matching bracket for KA 66-TW-K

Range of application
Drive position
Opening direction
Opening type
Notice: This product recommendation is based on the available and limited data and filter options. To determine a suitable installation solution, further information on the installation situation, the window profile and the usage requirements is necessary. For the specific selection of a suitable bracket for installing to the window, use our myCalc configuration tool or contact our project consultants directly and personally for planning support.